Light metal is special milling cutter F2250

  • Time:
  • Click:103
  • source:BERO CNC Machining
F2250 of special milling cutter separates light metal to take blade holder is mixed do not bring blade holder two kinds of structures. Characteristic: Tool cutting edge angle of same cutter hub is 3 kinds: Appearance of 90 ° razor blade, size is 75 ° of 45 ° 4 kinds: SPH.

1204.

.

SD.

.

09T3.

.

APHT0903.

.

APHT15T3.

.

Appearance of 3 kinds of point machines with suiting to differ: A88- - 0 degrees before horn and sharp point appearance, use at diamond razor blade; G88- - 20 degrees before horn and sharp point appearance, use at SD.

.

09T3.

.

Bit; K88- - 25 degrees before horn and sharp point appearance, use at APHT.

.

Bit. Axial is adjustable contain the balance that is used at dynamic balancing fine tuning to adjust bolt not to take blade holder cutter hub to use tall alloy steel to make, and the above of cutter hub F100 that brings blade holder uses high strenth aluminium alloy to make, contain the covering layer with admirable wearability to install the cutting speed Vc= 4 that uses diamond bit, 300 - 7, structure of 000 M/min knife handle: Cylinder straight handle; Cover type. Limits of cutting tool diameter: Do not take blade holder cutter hub: F63-f100; Take cutter hub of blade holder steel: F80-f100; Take cutter hub of blade holder aluminium alloy: F125-f200. CNC Milling CNC Machining