In world each district, have plastic treatment business and die manufacturer are using Ou Ruikang Baerchasi besmears layer coating will enhance its product competition ability. The tool noting a pattern that lower production cost uses BALINIT® coating can prolong service life significantly, shorten periodic time improves performance characteristics, can improve productivity thereby and reduce unit cost. The effect that write a standard is much better after coating of the BALINIT® on besmear, frit expects but flow time is longer, the effect that writes a standard is better also. Infuse pressure can hold longer time, reduced shrink mark thereby. Reduced BALINIT® of force of drawing of patterns to be able to reduce conglutinate liability, make drawing of patterns lighter. Can avoid to use agent of drawing of patterns normally. When wearability should handle the frit of tall abrasiveness higher to expect, the hardness of coating can be reduced substantially wear away. In addition, mix in cleanness during maintaining, coating can return the effect that can have to prevent a mould to be damaged. Quality of the product that note a pattern is much better better as a result of the quality that write a standard, be out of shape decrease and tool surface is shining, the part that production gives produces character to measure much better, percent defective to reduce. Wear away goodly the color change of indicator coating surface can reflect a wear out condition as early as possible, can make costly mould and lining get in time rehabilitate thereby. Easily clean mould deposit decreases, carry simple kind can purify. Clean and periodic longer, clean rate is rapidder, make tool utilization rate is able to rise. Without lubricant because coefficient of friction is low,move, the mould spare parts that can prevent shift effectively (for example, core of ejector, slideway, oriented component, unscrew) be stayed in by scratch or card, although be in,do not have lubricating also is such below the condition that run. CNC MillingCNC Machining